A
atif
Guest
I tried running Nema 17 stepper motor using the drive in the pic below (not the basic L298N drive, which BTW I successfully used to rotate the motor) .
Could any of you review my existing connections and guide me to complete the remaining ones?
Existing Arduino Uno, Nema 17 motor and drive setup:
Existing connections to Drive from left to right:
What I am missing is connections to PUL, DIR, VCC and ENA. I could put the 4 wires from Arduino D8 to D11 respectively but is that enough? Is there an Arduino sketch I could refer to after the connections are ready?
Login To add answer/comment
Could any of you review my existing connections and guide me to complete the remaining ones?
Existing Arduino Uno, Nema 17 motor and drive setup:
Existing connections to Drive from left to right:
- Thick yellow wire (0v) from power adapter along with a thin black wire (Ground) from Arduino
- Thick red wire (12v +) from power adapter
- Green wire (A+) from stepper motor
- Black wire (A-) from stepper motor
- Red wire (B+) from stepper motor
- Blue wire (B-) from stepper motor
What I am missing is connections to PUL, DIR, VCC and ENA. I could put the 4 wires from Arduino D8 to D11 respectively but is that enough? Is there an Arduino sketch I could refer to after the connections are ready?
Login To add answer/comment